Replace completely using the Alpha V1 Rebuild Kit (Part #JV1-DK). 6. Troubleshooting and Error Codes

Connect the high-voltage electrostatic cable to the terminal. Ensure the grounding strap is securely fastened to the machine chassis to dissipate residual static charges safely.

: Switch on the heater via the main isolation switch (usually outside the bathroom). Adjust Temperature

The water inlet sits on the bottom right of the heater, while the hot water outlet sits on the bottom left. Do not reverse these connections.

a specific print quality issue (e.g., "choppy" text) Translate technical diagrams for fluidic paths

Requires a dedicated fuse or MCB (typically depending on kW rating) and appropriate conductor size (e.g., 4.0 mm²). Plumbing:

Plug the Control Unit into a grounded 110V/220V AC power source. 3. System Calibration and First-Time Setup

: Use the control dial on the front panel. Turning the dial clockwise increases the temperature. For hotter water, you can also lower the water flow rate. Flow Control