Xycd60 Manual 2021 〈2026 Edition〉

Percentage=Current Voltage−dnUP−dn×100%Percentage equals the fraction with numerator Current Voltage minus dn and denominator UP minus dn end-fraction cross 100 %

: Long-press the SET button to toggle between two primary modes: xycd60 manual

| Code | Function | Description | Range/Default | | :--- | :--- | :--- | :--- | | | Heating / Cooling Mode | Sets the relay to activate on temperature drop (Heating) or rise (Cooling). | H (Heating) / C (Cooling) | | P1 | Hysteresis (Dead Band) | The difference between stopping and starting. If set to 2.0°C, the relay activates at Set Temp - 2°C (Heating mode). | 0.1°C – 15.0°C | | P2 | Delay Protection | Prevents rapid cycling of compressor/relay. (e.g., wait 3 minutes before restarting). | 0 – 10 Minutes | | P3 | High Alarm | Audible alarm triggers if temp exceeds this limit. | Off / Temp Value | | P4 | Low Alarm | Audible alarm triggers if temp drops below this limit. | Off / Temp Value | | P5 | Calibration | Corrects sensor reading errors. If actual temp is 25°C and display shows 24°C, set P5 to +1.0. | -5.0°C to +5.0°C | | Off / Temp Value | | P4

For the most detailed, up‑to‑date information, refer to the manufacturer’s documentation. allowing the load to run.

This prevents electrolyte boil-off in lead-acid batteries or cell damage in lithium packs. P-2 (Discharging Mode): The relay turns (Upper Limit), allowing the load to run. The relay turns

Make sure to hold the set button until the screen flashes to confirm changes.